We had a power outage this week. Some devices on my home network got new IP addresses when the power came back on. One of the devices that got a new IP address was my Brother MFC-9340CDW printer/scanner/fax. The printer was still working fine, but I couldn’t scan.
The tl;dr is to remove the old configuration and set the new one:
sudo brsaneconfig4 -r MFC-9340CDW sudo brsaneconfig4 -a name=MFC-9340CDW model=MFC-9340CDW ip=192.168.0.124
I got the new IP address from poking buttons on the front panel of the printer. The name of the device may be different, but the above is what I had from the default setup.
brsaneconfig4 -q gives all the devices supported, and also the last line is the current configuration. That’s useful to see what the currently configured IP address is, according to the software on the computer.
To figure out what was wrong with
simple-scan, I did this in a terminal to see debugging output:
Another useful command is:
ping on the scanner. However, in my case another device had the scanner’s old IP address, so the
ping appeared to be working fine.